Tel:

180-8888-6977

新闻资讯

News Center

current position: Home > News Center > Company News

What points should be paid attention to when the copper ball automatic cleaning machine is operated

2021-10-23 08:22:39
times

Copper ball automatic cleaning machine is a kind of equipment that uses ultrasonic wave for cleaning operation. It has the advantages of good cleaning effect, simple operation and flexible use. It is widely used in surface spraying treatment industry, machinery industry, electronics industry, medical industry, semiconductor industry, Wall clock jewelry industry, optical industry, textile printing and dyeing industry and other fields. In the laboratory, thecopper ball automaticcleaning machineis also a product with a high utilization rate.

 

  So what problems should be paid attention to when using the copper ball automatic cleaning machine ?

 

  1. Copper ball automatic cleaning machine installation.

  Refer to the installation manual of the copper ball automatic cleaning machine to connect the temperature control sensor signal line, ultrasonic drive line, heater control line and other lines between the electric control cabinet of the cleaning machine and the host, and connect the 380VAC power supply, install the water supply pipe of the cleaning machine, put Water pipes and overflow drains.

 

  2. Add water to the copper ball automatic cleaning machine .

  Add an appropriate amount of clean water to the cleaning pool, and the height of the liquid level is subject to immersion of the parts to be cleaned, generally not more than three-quarters of the cleaning pool.

 

  3. Ultrasonic cleaning machine heating.

  Turn on the electric control heating switch, and point the white scale line on the water temperature adjustment knob to the appropriate temperature (should be about 60°C). During the operation of the cleaning machine, the maximum temperature of the cleaning machine should not exceed 70 ℃.

 

  4. Add cleaning agent to the copper ball automatic cleaning machine .

  When the water temperature rises to about 40°C, add the parts cleaning agent to the cleaning tank (usually about 5kg at a time), and slowly stir the water to fully dissolve it (you can also start a supersonic wave or open the aeration device for stirring).

 

  5. Copper ball automatic cleaning machine pretreatment.

  Before cleaning, it is advisable to use a bamboo knife to briefly clean the dirt on the surface of the parts to prolong the service life of the cleaning solution.


Previous:None

Recently Viewed:

contact

Mobile: 180-8888-6977 (Mr. Li)     Tel: 0755-23341037     QQ: 345976346

Add: Plant No. 224, Guangtian Road, Tangxiayong Community, Yanluo Street, Baoan District, Shenzhen

SCAN

SWEEP